Rockwell RS2111, Руководство пользователя

Страница: 8 / 11

CORDLESS IMPACT DRIVER EN
8
TECHNICAL DATA
OPERATING INSTRuCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
1. CHARGING THE BATTERy (See Fig. A)
CHARGING PROCEDuRE
1) Plug the charger into an appropriate outlet. The
light (a) will be green.
2) Insert the Battery Pack (4) into the charger, the
light (b) will be red and flash to indicate the
charging process has started.
3) On completion of charge, the light (a) is green, and
light (b) will illuminate red, and won’t flash. The
pack is now fully charged, unplug the charger and
remove the battery pack.
wARNING: When battery charge runs out after
continuously use or exposure to direct sunlight
or heat, allow time for the tool to cool down before
re-charging to achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems
that can arise with battery packs. Indicator lights
indicate problems (see table below). If this occurs,
insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the
original pack is defective and should be returned to
a service center or recycling service center. If the
new battery pack displays the same problem as the
original Battery Pack, have the charger tested at an
authorized service center.
Light ON/OFF Flash Status
Green on
Red flash
Charging
Red flash
Green flash
Defective
Battery
Green on
Red on
Fully Charged
Green Off
Red flash
Hot/Cold Delay
2. TO REMOVE OR INSTALL BATTERy PACk (See Fig. B)
Depress the Battery Pack release button (3) to release
and slide the Battery Pack out from your tool. After
recharge, slide it back into your tool. A simple push
and slight pressure will be sufficient.
3. INSERTING A BIT HOLDER, SOCkET OR SCREwDRIVER
BIT
Pull the Collet Locking Sleeve (7) forward. Fully insert
the desired bit into the chuck to the stop and release
the Collet Locking Sleeve.
4. REMOVING A BIT HOLDER, SOCkET OR SCREwDRIVER
BIT (See Fig. C)
Pull the Collet Locking Sleeve(7) forward. Take the
tool out of the chuck and release the Collet Locking
Sleeve.
5. SwITCH LOCk
The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger,
place the direction of rotation selector in the center
position.
6. REVERSIBLE (See Fig. D1&D2)
For drilling and screw driving use Forward Rotation
marked “ ” (lever is moved to the left). Only use
Reverse Rotation marked “ ” (lever is moved to
the right) to remove screws or release a jammed drill
bit.
wARNING: Never change the direction of
rotation when the chuck is rotating, wait until
it has stopped!
7. LED LIGHT (6)
To turn on the light simply press the On/Off Switch
(5). When you release the On/Off Switch, the light will
be off.
Battery voltage
No-load speed
Impact rate
Max torque
Chuck Size
Charger voltage
Charging time
Battery capacity
Machine weight
12V
0-2200 /min
0-3000/min
80N.m
1/4
˝
100-240V~ 50Hz
1 hr
1.3Ah Li-ion
0.95kg