Rockwell RG8166, Руководство пользователя

Страница: 13 / 16

13
18V 250MM GRASS TRIMMER EN
4. TO MANUALLY FEED THE LINE (SEE FIG. H)
If required, line can be fed out manually. Before
manually feed, remove the battery first. To operate,
press and release manual line feed button (B), while
gently pulling out the lines until the lines reach the
line cutter. If the line extends past the line cutter, too
much line has been fed out. If too much line is fed
out, remove the spool cap and turn spool counter-
clockwise until the line is at the desired length.
5. To remove the cap (SEE FIG. I)
Press and hold in the two latches (See Fig. I). Pull cap
away from the spool holder. When refitting the spool
cap. Keep all areas of the cap and spool holder clean.
Replace the cap, pressing firmly down towards the
spool holder to ensure cap is fully located. Check that
the cap is correctly fitted by trying to remove it without
depressing the two latches.
6. To change the spool (SEE FIG. J)
Note: For your convenience it is recommended
you buy replacement spools with the trimmer line
preinstalled.
Remove Spool Cap Cover. Remove the old Spool from
Spool Holder. Clear any broken line or cutting debris
from the spool area. Pull the line from the new
replacement Spool through the eyelet of the Spool
Holder. Place new Spool into the holder with the cut
out areas of the Spool facing inward or down. When
installed into the Spool Holder, the smooth side of the
Spool should be visible. Release line from cleat on
the Spool. Refit the Spool Cap Cover.
7. To Manually Wind line (See Fig K1-K3)
Important! Your trimmer is designed to use only line
with a maximum diameter of 1.65mm.
Take approximately 3m of line. Insert 15mm of line into
the spool holes and wind line in the direction of the
arrows on the top of the spool. (See Fig. K1, K2) Leave
approximately 100mm of line unwound and place it
into the cleat. Care should be taken to ensure that the
line is neatly coiled on the spool. (See Fig. K3) Failure
to do so will impair the efficiency of the automatic
line feed. Then fit the spool as described above in “To
changing the Spool”.
STORING YOUR GRASS TRIMMER
Always remove the battery pack from your
trimmer after use.
Store in a dry place where the trimmer and battery can
be protected from damage.
MAINTENANCE
Remove the battery before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean.
Keep all working controls free of dust. Occasionally
you may see sparks through the ventilation slots. This
is normal and will not damage your power tool.
If the charger supply cord is damaged, it must be
replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.