Rockwell RCV144ACx, Справочник по командам

Страница: 97 / 186

AT Command Reference Manual
1048 4-17
S38 - Delay Before Forced Hang Up
This register specifies the delay between the modem's receipt of the H command to disconnect (or ON-to-OFF transition of
DTR if the modem is programmed to follow the signal), and the disconnect operation. Applicable to error-correction
connection only. This register can be used to ensure that data in the modem buffer is sent before the modem disconnects.
1. If S38 is set to a value between 0 and 254, the modem will wait that number of seconds for the remote modem to
acknowledge all data in the modem buffer before disconnecting. If time expires before all data is sent, the NO CARRIER
result code will be issued to indicate that data has been lost. If all data is transmitted prior to time-out, the response to
the H0 command will be OK.
2. If S38 is set to 255, the modem does not time-out and continues to attempt to deliver data in the buffer until the
connection is lost or the data is delivered.
Range: 0-255 seconds
Default: 20
S39 - Flow Control Bit Mapped Options Status
Default: 3 (00000011b)
Bits 0-2 Status of command options
0 = No flow control
3 = RTS/CTS (&K3) (Default.)
4 = XON/XOFF (&K4)
5 = Transparent XON (&K5)
6 = Both methods (&K6)
Bits 3-7 Reserved