Rockwell powerflex 700h, Руководство по программированию

Страница: 51 / 104

Programming and Parameters 2-37
Selected Option Definitions – [Analog Outx Sel], [Digital Inx Sel], [Digital Outx Sel]
INPUTS/OUTPUTS
Digital Outputs
381
385
389 [Dig Out1 Level]
[Dig Out2 Level]
[Dig Out3 Level]
Sets the relay activation level for options
10 – 15 in [Digital Outx Sel]. Units are
assumed to match the above selection
(i.e. “At Freq” = Hz, “At Torque” = Amps).
Default:
Min/Max:
Units:
0.0
0.0
0.0
0.0/1500.0
0.1
380
384
388
382
386
390 [Dig Out1 OnTime]
[Dig Out2 OnTime]
[Dig Out3 OnTime]
Sets the “ON Delay” time for the digital
outputs. This is the time between the
occurrence of a condition and activation
of the relay.
Default:
Min/Max:
Units:
0.00 Secs
0.00 Secs
0.00 Secs
0.00/163.00 Secs
0.01 Secs
380
384
388
383
387
391 [Dig Out1 OffTime]
[Dig Out2 OffTime]
[Dig Out3 OffTime]
Sets the “OFF Delay” time for the digital
outputs. This is the time between the
disappearance of a condition and
de-activation of the relay.
Default:
Min/Max:
Units:
0.00 Secs
0.00 Secs
0.00 Secs
0.00/163.00 Secs
0.01 Secs
380
384
388
File Gr
oup
No.
Parameter Name & Description Values
Related
Option Description Related
At Speed Relay changes state when drive has reached commanded speed. 380 384 388
Excl Link Links digital input to a digital output if the output is set to “Input 1-6
Link.” This does not need to be selected in the Vector option. 361 - 366
Input 1-6 Link When Digital Output 1 is set to one of these (i.e. Input 3 Link) in
conjunction with Digital Input 3 set to “Excl Link,” the Digital Input 3
state (on/off) is echoed in the Digital Output 1. 380 384 388
MOP Dec Decrements speed reference as long as input is closed. 361 - 366
MOP Inc Increments speed reference as long as input is closed. 361 - 366
Param Cntl
(A.O.) Parameter controlled analog output allows PLC to control analog
outputs through data links. Set in [AnlgX Out Setpt], par. 377-378. 342 345
Param Cntl
(D.O.) Parameter controlled digital output allows PLC to control digital
outputs through data links. Set in [Dig Out Setpt], parameter 379. 380 384 388
PI Reference Reference for PI block (see page B-8 ). 342 345
Run Level Provides a run level input. A run level input does not require a
transition for enable or fault, but does require a transition for a stop. If
a “Stop” input is used to reset faults the “Run Level” input must be
transitioned when the 24V DC internal supply is used. 361 - 366
Run w Comm Allows the Comms start bit to operate like a run with the run input on
the terminal block. Ownership rules apply. 361 - 366