Rockwell Automation Guardmaster 440R-ENETR, Руководство пользователя, Страница: 33 / 86

Rockwell Automation Publication 440R-UM009C-EN-P - July 2019 33
Add the AOP to a Studio 5000 Project Chapter 5
Add Relays to the ENETR
Interface
There are two ways to add relays to the ENETR interface.
• Upload Method
This preferred method requires the physical system to be complete,
including relays, taps, and communications with the ENETR interface.
• Manual Method
This method can be used before the physical system being complete. This
method requires you to select each relay in its specific location. If a DG
safety relay is used, you must also select the type of tap and its specific
location in the GuardLink circuit. For more information, see Manual
Method on page 36 .
Upload Method
The steps of the upload method follow steps 1 … 11 on pages 31 … 32 .
1.
Click Upload ( Figure 35 ).
Figure 35 - Module Definition
2.
To select the upload path, click the ENETR interface ( Figure 36 ).
3. Click OK.
Figure 36 - Select Path
The Upload Complete message ( Figure 37 on page 34 ) confirms the
operations.