42
6185 Economy Line Monitors
Publication 6185-UM003C-EN-P
Enabling the Touchscreen Interface
The 6185 Economy Line monitors provide a female DE-9 connector on
the side panel. This connector provides the serial interface for the touch
controller.
Interconnecting wiring to the host serial port connection is shown in the
following table.
Table G
Touchscreen Interface
Monitor
(DCE Device)
Host (DTE Device)
DE-9 (Female)
Signal Description
DE-9 (Male)
DB-25 (Male)
1
Not Connected (DCD)
1
8
2
Transmit Data (TXD)
2
3
3
Receive Data (RXD)
3
2
4
Data Terminal Ready (DTR)
4
20
5
Common Signal Return (SG)
5
7
6
Not Connected (DSR)
6
6
7
Request To Send (RTS)
7
4
8
Clear To Send (CTS)
8
5
9
Not Connected
9
22
Installing the Touchscreen Driver Software
To install the touchscreen driver software correctly, obtain the following
information about the host hardware:
•
The COM port in use for the touchscreen. Ensure that the RS-232
cable is properly installed between the monitor port and the host’s
COM port.
•
The baud rate at which the controller is operating. You will need to
match the baud rate at the COM port. The controller baud rate is
factory set at 9600.
Note:
•
If you are using older touchscreen software, you may be
prompted for the type of touchscreen controller being
used. The 6185 Economy Line monitors use Resistive:
Elo TouchSystems model E271-2210 controllers.
Once you have obtained this information, install the software using the
installation disks found in the touchscreen accessory package.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com