Rockwell Automation Allen-Bradley 6181X, Оригинальное руководство пользователя

Страница: 21 / 32

Rockwell Automation Publication 6181X-IN002D-EN-P - February 2020 21
Industrial Computers for Hazardous Locations
Remove the Cover
To install, replace, or upgrade internal computer components, you must first remove the cover.
Follow these steps to remove the rear cover.
1. Follow the steps for Preconfiguration on page 20 .
2. Loosen the three screws that secure the rear cover (A).
3. Open the cover (B) and detach it from the chassis (C).
4. After you have installed, replaced, or upgraded internal computer components, reinstall
the cover as detailed in
Reinstall the Cover on page 21 .
Reinstall the Cover
Follow these steps to reinstall the rear cover.
1. Follow steps 1…3 for Post-configuration on page 20 .
2. Reattach the rear cover to the chassis (D).
3. Close the cover (E).
4. Tighten the three screws to secure the rear cover (F).
5. Follow steps 5 and 6 for Post-configuration on page 20 .
Load a CompactFlash Card
The computers have one location to load a CompactFlash (CF) Type II card, which is the slot on
the I/O port panel below the serial ports. This slot is functionally hot-swappable but only in a
non-hazardous location. It is meant to be a data slot but it is bootable.
A
B
A
A
C
C
F
E
F
F
D
D