Rockwell Automation Allen-Bradley 20-750-TLINK-FOC-10, Руководство пользователя, Страница: 5 / 28

Rockwell Automation Publication 750COM-UM100A-EN-P - June 2021 3
Preface
About This Publication
This user manual explains how to use a TLink option module to create a TLink
system. A TLink system can use multiple drives and is based on Connected
Components Workbench™ (CCW) software and PowerFlex® 750-Series AC
Drives with TotalFORCE® Control.
Introduction
The TLink option modules are used to create a high speed, communications
network with excellent reliability between PowerFlex 755T drive products. A
TLink based system consists of at least two drives, each with one TLink option
module, which is connected by a fiber-optic cable. One drive is considered the
leader and all other drives in the network are considered followers. TLink
option modules provide synchronization of all drives in the system and allow
them to share data from the leader drive to the follower drives.
Conventions Used in This
Manual
The following conventions are used throughout this manual:
• PowerFlex 755TL low harmonic drives, PowerFlex 755TR regenerative
drives, and PowerFlex 755TM drive systems are also referred to as
PowerFlex 755T drive products.
• The TLink option module card can be used with any 755T control pod
(drives, bus supplies, and common bus inverters). Unless specificity is
necessary, the products are all referred to as 755T drive products.
• Parameter names are shown in the format Parameter
XX:xxx
[*]. The
xx
represents the parameter number. The * represents the parameter
name—for example Parameter 01 - [Port Number].
• The HIM or drive firmware revision number (FRN) is displayed as FRN
X.xxx
, where ‘
X
’ is the major revision number and ‘
xxx
’ is the minor
revision number.