Rocktron REPLITONE MP, Руководство пользователя

Страница: 11 / 28

11
11
Please note, however, that this phantom power feature may not work with other MIDI
controllers. The Rocktron MIDI Controllers run on 9V AC current - others may not.
Therefore, please be sure you are fully aware of the functions and operation of other MIDI
controllers before using a 7-Pin DIN cable.
WARNING!! - The Rocktron RepliTone MP's phantom power is supplied to your footcontroller from the
RepliTone MP's adapter (you do not have to plug your Rocktron foot controller's adapter into the back of
the of the unit like you do on some other Rocktron models). Therefore, if you are using a 7-pin DIN MIDI
cable do NOT plug your foot controller's adapter into the footcontroller itself. Doing so may damage the
RepliTone MP and/or your foot controller. Please note that Rocktron does not assume any liability for
improper connections to or from this product.
HEADPHONE/DIRECT/RECORDING OUTPUT jack
Plugging either headphones or a stereo Y cable into this jack will activate the RepliTone
MP's speaker simulator. This jack has been specifically designed to be used in several ways:
-For Direct Recording (use a stereo Y cable for left and right)
-For Direct connection to a PA system (use a stereo Y cable for left and right)
-For Headphone listing.
This feature allows you to use a stereo Y cable (not included) to run into a PA system
(eliminating the need to haul the power amp and speaker cabinets to the gig) or allow you
to record direct into a mixing board or home studio.
If you do not have a stereo Y cable you can activate the speaker simulator out of the Left &
Right Pre-amp outputs by plugging in a 1/4” guitar cable or 1/4” stereo dummy jack into
this headphone/direct/recording output jack and then use two standard 1/4” guitar cables
from the Pre-amp outputs into the PA or recording device.
LOOP SEND and RETURN jacks
The effects loop is provided to allow for a chain of external stereo (L/R) effects devices to
be inserted into the signal path after the preamp and built-in effects and before the power
amp.
NOTE: To maintain stereo operation, the effects loop must be used in a stereo configuration. This requires
only stereo RTS connections to be made to the send and return jacks. Using mono TS (tip-sleeve) connections
will mute the right channel.
POWER jack and ADAPTER
Provides AC power to the Replitone MP - please use the enclosed 9VAC 3.4 amp adapter
for this product only. Do not use any adapter other than the included adapter. Rocktron is
not responsible for improper use. Please follow all precaution instuctions included in the
front of this manual. Replacement adapters are available. Here are the model numbers:
Model Number 006-1211 - this is a 110V 9VAC 3.4A Adapter 4 Pin/Din for RepliTone MP
Model Number 006-1224 - this is a 220V 9VAC 3.4A adapter 4 Pin/Din for RepliTone MP
Please check our website for more details www.rocktron.com
5
6
4