Rocktron HUSH 2X, Инструкция по эксплуатации

Страница: 5 / 20

For maximum noise reduction results, place the HUSH after
your distortion and modulation effects (chorus, flanger,
phaser, etc.) but before any delay or reverb effects. If you
are already comfortable rolling back your guitar’s volume
pot, simply turn your distortion and other effects in the
chain before the HUSH to “ON”, roll back your volume
pot, adjust the HUSH Threshold control to remove any hiss
you hear, and you are ready to go!
Make sure you pay attention to the proper setup by placing
the HUSH AFTER your noisy stomp boxes or in your
amp’s effects loop. The HUSH is NOT designed to take the
input directly from your guitar WITHOUT some process-
ing happening between the guitar and the noise reduction.
When setup correctly, with your signal going from your
preamp and effects, or from your distortion and effects, into
the HUSH, you will love how it cleans up the excess noise,
including pickup buzz! The HUSH can also be used in
your amplifier’s effects loop. However, if you are running
multiple effects through this loop, the HUSH should always
be the last dynamic device in the signal chain, but before
digital delays or reverbs.
The HUSH will give you the same great HUSH noise
reduction used by thousands of high profile artists for years!
The switches on the HUSH 2X controls On/Off status of
each channel as shown by the LED indicator. The HUSH
2X runs on a 9V Alkaline battery, or may also be powered
by Rocktron’s DC OnTap Universal Power Supply adaptor.
Introduction continued....