38
MIDI, Page 5 of 7 - Program Change Status
The fifth page of the MIDI program,
Program Change Status
, determines
whether or not the All Access will respond to incoming program changes, as well
as whether to map the incoming program changes to a preset.
If the All Access is set to respond to incoming program changes, it will
send out information associated with each preset just as if the buttons on the All
Access were pressed.
(This feature is operable only when the All Access is
operating in BANK mode - see SETUP, Page 1).
When set to
OFF
, the All Access will not respond to incoming
program changes.
When set to
ON
, he All Access responds to incoming program
changes without mapping.
When set to
MAP
, the All Access responds to incoming program
changes and maps any assigned patch changes (
see MIDI, page 6
).
To set the program change status:
(
) With the 2ND L.E.D. still lit, press the "
ð
" switch to access the next page
of the MIDI program,
Program Change Status
. (If the All Access is not
already in the MIDI editing mode, press "2ND", then "MIDI", followed by
"
ð
" four times.)
(
) Use the "INC" and "DEC" switches directly below the displayed Program
Change Status to select the desired status.
Содержание ALL ACCESS
Страница 1: ...U S E R S M A N U A L ALL ACCESS TM ...
Страница 8: ...5 Typical Setup Typical Setup ...
Страница 10: ...7 Using phantom power with a non Rocktron MIDI receiving device ...
Страница 75: ...72 Expression Pedal Cords Expression Pedal Cords ...
