5
6. Slide the Sled Body (1) backward so that it will be clear
of the blade.
Blade height should be set no more than 2"
above the surface of the saw table to avoid saw blade from
contacting aluminum T-track on the fences.
7. With the saw off, raise the saw blade, using the markings on
the back of the plastic Drop-Off Ramp (3) as a guide to set
the correct maximum blade height (no more then 2" above
the table saw surface).
Fig. 3.
8. With the full Sled Body (1) at the front of the saw, clear of the
blade, turn on the saw and push the sled through the blade,
stopping well before the blade emerges out the back of the
plastic Blade Guard (6).
Fig. 4.
Turn off the saw and allow the blade to
stop spinning before sliding the Small Parts Sled back to the
starting point at the front of the saw.
9. With the blade still raised but the saw turned off and
unplugged, slide the sled back to the point where you
stopped in Step 8.
Fig. 3
Fig. 4
