Rockler Material Mate, Инструкция по эксплуатации

Страница: 6 / 8

6
1. Position the Material Mate ™ far enough from your vehicle
so you will be able to center the sheet on the cart
during unloading
.
2. Engage the Locking Casters (17) and rotate the Flip
Stops (24 and 25) on the Table Extension (23) to the side
so they are parallel to the Table Extension (23) and tighten
the 4-Star Knobs (10). Fig. 6.
3. Make sure the Latch Arm (26) is fully engaged to keep the
top secure in a horizontal position and to prevent it from
inadvertently tipping upright. Fig. 7.
To avoid accidental Vertical tilting and
unintended movement of the materials, Latch Arm (26)
must be fully engaged (“clicked” to hold together the
Frame Assembly (22) and Crossbar (21))
4. Pull the Safety Locking Pins (8) from the Vertical
Supports (20) and depress the bullet pins to pull the
Table Extension (23) outward. Continue to pull the Table
Extension (23) until the pins re-engage. The Locking
Pins must be re-inserted to secure the Table Extension (23)
in place. Fig. 8.
5. Pull the sheet of material onto the Material Mate ™ and center
it on the cart.
6. Adjust the position of the sheet material until the long
edge nearest the Table Extension (23) is flush with
the Table Extension (23).
7. Rotate the Flip Stops (24 and 25) up and secure in place by
tightening the 4-Star Knobs (10). Failure to secure the knobs
could allow potentially dangerous shifting of the material
during transport. Fig. 9.
8. Make sure the sheet remains centered on the cart, both front
to back and side to side. Off-center positioning could cause
the load to become unstable or the cart to tip.
11. Adjust the height of the Material Mate ™ cart by removing the
1/4" x 1
1
⁄
2
" Bolts (6) and 1/4" Flange Nuts (4) holding
the Vertical Supports (20) to the Leg Supports (19) and
reattaching using the sets of holes that produce the proper
height. The Material Mate ™ must be assembled so that its
height, when the Frame Assembly is flat, is at least 1/2"
below the surface of the table saw. This includes any top
attached to the Material Mate ™ . Fig. 5.
Material Mate Loading
> Overloading cart will cause tipping and potential
injury. Do not load more than one sheet of 3/4"
thick (max.) material at a time.
WARNING
Fig. 7
Fig. 6
Fig. 5
> Do not attempt to lift more than you are
physically able. Get help if necessary. Use
proper lifting techniques.
CAUTION
Table Saw
Material Mate
1/2" minimum
25
23
24
26
21
22