7
Mounting to Wall Studs
1. Mark the locations for the top two mounting screws and drill
pilot holes for 3/8" x 2" Lag Screws (21).
2. Fit a 3/8" Flat Washer (22) onto each screw. Drive the screws
into the studs until they’re about 1" from being fully seated.
3. Decide whether you want the Handle of the Hose Reel to be on
the right or the left side. Orient the Hose Reel as desired and
lift it onto the top two 3/8" x 2" Lag Screws (21).
Fig. 1.
4. Mark the locations for the bottom two 3/8" x 2" Lag
Screws (21), using the bottom keyhole slots in the
Base Plate (2) as a guide.
5. Lift the Hose Reel off the top two Lag Screws (21) to remove it.
Drill pilot holes for the lower set of Lag Screws (21).
6. Return the Hose Reel onto the top two Lag Screws, making
sure that the 3/8" Washers (22) make it through the keyhole
openings in the Base Plate (2). Check that the Hose Reel is
level and then drive the 3/8" x 2" Lag Screws (21) until they
are fully tightened.
Fig. 2.
7. Fit a 3/8" Flat Washer (22) onto each of the remaining two
3/8" x 2" Lag Screws (21) and drive the screws into the lower
two pilot holes to fully secure the Hose Reel.
Attaching Hoses
1. Attach your 1
1
⁄
2
" hose to a port that has a 2
1
⁄
4
" outside diameter
on one end.
2. Press the 2
1
⁄
4
" OD end of the port into the Shop Vacuum Port
on the inside of the Hose Reel
.
Fig. 3.
3. Unscrew the Hose Retraining Strap (18) from the Right
Hub (6) and fit the strap around the hose.
Fig. 2
Fig. 2
Fig. 1
21
22
22
21
> The Hose Reel must be mounted to wall studs spaced
16" on center using 3/8" x 2" Lag Screws (21) AND
3/8" Washers (22).
> Failure to mount the Hose Reel according to the
included instructions could result in personal injury
or damage to property.
> Do not mount the Hose Reel higher than your own
shoulder height.
> Do not hang or coil objects other than the specified Shop
Vacuum Hose from the Hose Reel.
> Do not leave uncoiled dust hoses on the floor as they
can cause tripping hazards.
22
21
