4
Distributed by Rockler Companies, Inc.
Medina, MN 55340
48403
Rev 12/18
Check Rockler.com for updates. If you have further questions, please
contact our Technical Support Department at 1-800-260-9663
Assembly
1. Press the Center Band (5) onto the tenon cut on the
blank containing the Upper Tube (4). If the Center Band
is a little loose, glue it in place with a small drop of
CA (cyanoacrylate) glue.
2. Use a pen press or a clamp to press the Cap Coupler (3),
chamfered end first, into the other end of the blank containing
the Upper Tube (4) until the shoulder is flush with the blank.
3. Insert the threaded stud of the Cap (1) through the Clip (2)
and thread the assembly into the Cap Coupler (3).
4. Use a pen press or a clamp to press the Tip into the narrow
end of the blank containing the Lower Tube (7).
5. Use a pen press or a clamp to press the Twist Mechanism (6),
brass end first, into the other end of the blank containing the
Lower Tube (7), up to the Indentation Ring. To determine if
the Twist Mechanism is positioned to the correct depth, thread
the Ink Cartridge (8) into the Twist Mechanism. When the
Ink Cartridge is properly fitted, approximately 1/8” of the
writing point shows when the mechanism is twisted open,
and the writing point is concealed when the mechanism is
twisted closed. If the point does not extend far enough, remove
the Ink Cartridge and press the Twist Mechanism slightly
farther into the tube. Test the writing tip extension again
and repeat the process as necessary.
6. Thread the Ink Cartridge (8) into the Twist Mechanism (4),
and then gently push the Upper and Lower assemblies
together by hand, taking care to match the grain
alignment marks to preserve grain continuity.
Be careful not to press the Twist
Mechanism in too far as it cannot be pulled back out.
Stock #
Pro Pen Turning Mandrel, #2 Morse Taper
49514
Pro Pen Turning Mandrel, #1 Morse Taper
44309
Adjustable Pen Turning Mandrel, #2 Morse Taper
48377
Adjustable Pen Turning Mandrel, #1 Morse Taper
44341
Fisch 7mm HSS M2 Pen Drill Bit
36372
Summit Bushing Set
41499
Barrel Cleaner/Pen Mill Kit
47526
OPTIONAL ACCESSORIES
1 Cap
2 Clip
3 Cap Coupler
4 Upper Tube (Short)
5 Center Band
6 Twist Mechanism
7 Lower Tube (Long)
8 Tip
9 Ink Cartridge
PARTS LIST
1
2
3
4
7
5
6
8
9
