7
Fig. 2
8.
Make sure that the J-bolts have been retracted enough to
accommodate the thickness of the drill press’s metal table
and then slide the Drill Press Table back into its centered
position on the drill press’s table. Make sure the capped feet
of all four J-bolts contact a flat surface on the underside of
the drill press’s metal table.
9.
Turn the J-bolts on each mounting bracket to secure
the Drill Press Table to the drill press’s table. Do
NOT
overtighten. Check to make sure the Drill Press Table
doesn’t shift.
Fig. 1.
10.
Reinstall the MDF sacrificial center insert.
Assembling and Installing the Fence
1.
After assembling the fence, install the fence on the Drill
Press Table by fitting the T-bolts into the holes at the front
end of the fence-adjustment slots in the table.
2.
Position the fence as desired and secure in place by
tightening the knobs.
3.
Connect a 2
1
⁄
2
" dust hose or fitting to the fence dust port.
Making a Replacement Center Insert
After a period of use, it might become necessary to replace the
MDF sacrificial center insert. To make one, simply cut a 9" x 3"
piece of 1/2" thick MDF. Other material could be used, but it
must be completely flat and measure exactly 1/2" thick. (Plywood,
for example, typically is slightly thinner than the nominal 1/2"
thickness advertised.)
Fig. 2.
3"
9"
Center Opening Pattern
Center drill
shaft here
Check Rockler.com for updates. If you have further questions, please
contact our Technical Support Department at 1-800-260-9663
Содержание 57484
Страница 5: ...5 1 2 2 2 2 3...
