5
Assembly
1.
Attach the Center Angle Brace (3) to the back of the long
middle legs of the Right and Left Leg Assemblies (1 and 2)
with two 1/4"-20 x 2” Machine Screws (8), four 1/4"
Washers (9) and two 1/4"-20 Nuts (10) at each mounting
location. Note that the 1/4" Washers go on front and
back of the legs.
Fig. 1.
2.
In the same manner, attach the Rear Leg Stretcher (4),
the longest of the stretchers, to the back of the fold-out
rear legs of the Right and Left Leg Assemblies (1 and 2).
Use two 1/4"-20 x 2" Machine Screws (8), four 1/4"
Washers (9) and two 1/4"-20 Nuts (10) at each mounting
location, with the Washers on the front and the back of
the legs.
Fig. 1.
3.
Attach the Right and Left Flip Stops (12 and 13) to the
back of the Right and Left Leg Assemblies (1 and 2) with
a Tri-Star Knob with Post (15). Place an M6 Washer (14)
between the Knobs and the Flip Stops, and thread the
Knobs into the integral nuts in the Leg Assemblies. Make
sure that the Flip Stops are on the correct Leg Assembly.
The lip on each Flip Stop should be toward the outside
of the Leg Assembly.
Fig. 2.
THESE WARNINGS PERTAIN
TO ALL REMAINING STEPS:
>
To avoid pinching or crushing your
fingers, keep your hands away from
the areas where the legs cross.
>
Make sure to fully tighten all fasteners.
Make sure you orient the Right and Left
Leg Assemblies (1 and 2) correctly for assembly. The
short upper leg sections without articulating feet must
be on the inside of the assemblies.
Fig. 2
2
1
12
14
15
13
