– 20 –
Antenna
Antenna Input
Installation Sleeve
Backstrap
4mm Max
CAUTION: Installation sleeve should be installed using the appropriate tabs
(refer to page 17)
• Install Source Unit by sliding unit into installation sleeve until it clicks into
place
• Mount Backstrap securely behind the instrument panel to prevent source
unit vibration
• Backstrap Screw should be
4mm max (use supplied screw)
• Connect Antenna to antenna jack on rear of source unit
• Antenna Ground should read
less than 0.05
Ω
between antenna and
chassis ground
• Remove Trim Piece and Installation Sleeve from source unit
• Factory Bracket should align with
two mounting holes on each side of
source unit
• ISO Screws should be
4mm max (use supplied screw)
• Connect Antenna to antenna jack on rear of source unit
• Antenna Ground should read
less than 0.05
Ω
between antenna and
chassis ground
• Install Source Unit into instrument panel
• Replace Trim Piece on source unit if needed
Antenna
Antenna Input
Factory Bracket
4mm Max
Installing the Source Unit – ISO Mount
I
N
S
T
A
L
L
A
T
I
O
N
®
®
Installing the Source Unit – Standard Mount
Trim Piece
Trim Piece