CPU0204
6
To clean the working area, turn the nozzle to STREAM position to obtain high pressure mode. Spray high-pressure
water onto working area to rinse off the work area and any remaining detergent.
CLEAN-UP AND STORAGE
Shutting Down the Pressure Washer
WHEN FINISHED USING THE PRESSURE WASHER, FOLLOW THESE STEPS TO SHUT DOWN THE UNIT:
Turn the pressure washer to the OFF position.
Turn off the water supply.
Before disconnecting high-pressure hose connection, point the gun in a safe direction and discharge the high-
pressure water.
Disconnect high-pressure hose from the pressure washer and gun.
Disconnect garden hose from the pressure washer.
Remove excess water from the pump by tipping the unit on both sides to drain any remaining water from inlet and
outlet fittings.
Remove Water Intake Filter and flush with water to remove dirt or debris. Return filter once cleaned.
Drain detergent reservoir and flush with running water.
Wipe away any remaining water on all parts and fittings.
Engage the gun safety lock.
Store the pressure washer, parts, and accessories in an area with a temperature above 0°C (32°F).
Winterizing and Long-Term Storage
FOLLOW ALL OF THE ABOVE SHUT-DOWN PROCEDURES,ADDING THE FOLLOWING STEPS....
After disconnecting the water supply, and before disconnecting the high-pressure hose, turn the pressure washer
on for 2-3 seconds, until any remaining water in the pump exits. Turn unit off immediately.
CONTINUED USE OF THE PRESSURE WASHER WITHOUT WATER SUPPLY ATTACHED WILL CAUSE SEVERE
DAMAGE TO THE UNIT!
Always store the pressure washer, parts, and accessories in an area with a temperature above 0°C (32°F).
WARNING
: FAILURE TO COMPLY WITH THESE STORAGE INSTRUCTIONS WILL RESULT IN DAMAGE TO
THE PUMP ASSEMBLY.
Maintenance
This pressure washer is supplied with a closed lubrication system, so no addition of oil is needed.
Check all hoses and accessories for damage prior to use.
Check the water intake filter periodically for deposits. Clean this filter regularly for maximum performance.
CLEANING TIPS
WARNING: ALWAYS TEST THE SPRAY IN AN AREA FREE AND CLEAR OF PEOPLE AND OBJECTS BEFORE
YOU SPRAYAT THE INTENDED CLEANING SURFACE.
Wood and Vinyl Decks
Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent reservoir and apply to the area
being cleaned at low pressure. For optimal results, reduce your work area to smaller sections and clean each section
one at a time. Allow the detergent to rest on the surface for a few minutes and then rinse at high pressure.
Do not let the cleanser dry. Always clean from left to right and top to bottom for best results. Rinse at high pressure
using the fan spray keeping the tip of the spray nozzle at least 6-9 inches from the cleaning surface. Maintain a further
distance from the cleaning area when using a direct spray.
Caution
:
For softer woods, increase the distance from the cleaning area.