Wii U™ GamePad:
1
Place the Wii U™ GamePad into the front charging port on the station
as shown below.
2
The Battery LED on the Wii U GamePad lights up orange during
charging and will turn off when the battery is fully charged.
Wii U™ Pro Controller:
1
Locate the mini USB charge cable on the bottom of the Wii U
Controller Charge Station.
V1 ENGLISH 12-1309
2
Insert the mini USB charge connector into the Wii U Pro Controller.
3
The charge status indicator LED will light up (orange) on the Pro
Controller while charging and turn off when fully charged.
Note
: When charging is complete, first unplug the AC adapter from the
AC outlet, then unplug the Pro controller by carefully pulling the mini
USB charge connector straight out from the controller. For best results,
charge in an area with a temperature of 50°-95°F (10°-35°C).
Specifications
Battery pack: Ni-MH battery pack × 2
AC Adapter: input 110V-220V
AC adapter: output DC 5V 2A
AC adapter cable length: 1 meter
Input voltage: 100-220V ~ 60Hz
Output power: 5V at 2A
Legal notices
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Warning
: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
“Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.”
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment.
“Cet équipement est conforme à l'exposition aux rayonnements IC limites établies pour un
environnement non contrôlé.”
90-day limited warranty
Visit www.rocketfishproducts.com for details.
Contact Rocketfish:
For customer service call 1-800-620-2790
www.rocketfishproducts.com
™ and © 2013 Nintendo. Licensed by Nintendo.
ROCKETFISH is a registered trademark of BBY Solutions, Inc. Registered in some countries.
Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2013 BBY Solutions, Inc. All Rights Reserved.
