Pag. 15
2.2.1. Primary slider control (D-15).
Is located below the ash pan. It is used basically for lighting the
fire, will control moving the handle right or left to open more or less.
2.2.2. Secondary slider control (D-16).
Is located above the loading door and is used to adjust the
combustion more or less. Slide the handle to right or left to open or close.
The closer the register, the dirtier the glass.
WARNING:
The positions indicated are according to technical characteristics table, in
any case these positions must be adapt according to the flue depression and
fuel quality.
2.3. Safety distances.
Appliances, furniture and other flammable or breakable items (textiles,
electronics, wood, wallpaper, glass, chalk paper, etc..) must not approach any point of the product it is
seen, and bear in mind that the outputs hot air cannot be objects or flammable items without safety
distances described in the
I: Technical characteristics.
2.4. Fire types.
This apparatus is an on and off fire. The smoke chamber must be closed except when
being loaded, to avoid any smoke out fuel debris. It is convenient when loading the fireplace, to avoid
any leak or smoke escape.
2.5. Authorized fuel.
The appliance should not be used as an incinerator and other fuels that are
forbidden by the manufacturer's authorized. As fuel only use natural wood logs
is not advisable to
use resinous wood is allowed.
Are forbidden other fuels, including liquid (sometimes used to start the fire).
The maximum length of the logs should not exceed the length specified in the technical data according
to model (
see Table I: Technical characteristics).
2.6. Loading and reload fuel.
It must take into account the maximum authorised load of fuel, ensuring
that when the recharge.
The fuel can’t overtake the limit, taking care not to exceed either in quantity or
size to the data specified above
(you can see the I: Technical Characteristics).
WARNING - IM PORTANT NOTE:
Interior parts vermiculite
SHOULD NOT BE HIT, especially when
done refueling.
If any of these parts are cracked, but is properly placed in your
site, does not alter the proper functioning of NI A POTENTIAL RISK.
The device
can be used normally.
These cracks do not pose any manufacturing defects so you do not fall under warranty
.
To light the fire using materials suitable for this purpose, such as fire pads, gel fire, paper and dry and
thin branches.
DO NOT USE GASOLINE, SOLVENTS OR ALCOHOL
.
To make the procedure ignition follow these steps: placing the burden on the central area of the
database from home, open the register primary and secondary maximum and then fire pledge . Once
the fire is lit, close the primary register to prevent excessive combustion and control the intensity by the
secondary registers.
When the fuel load is reduced you will have to recharge considering data specified above.
2.7. Opening the door (D-17).
With the help of the tool,
pull the handle out opens the door to close
perform the same steps in reverse.
2.8. Mechanism blockage.
It is compulsory to check any piece because they might get stuck after a
long period of time without using the fireplace.
2.9. Cleaning and maintenance.
2.9.1. Glass cleaning.
To clean the glass, the appliance must not be operating. Do not clean with any
liquid either the metal parts of the door or the seal, in order to prevent damage.
