20
• Position- 3 Perineal, 3 Anal.
To set a different value to the pre-set one, with the activated function, adjust each of the temperature,
pressure or position parameters to the desired level and press the + and - buttons simultaneously on the
remote control for 3 seconds.
Each temperature, pressure or position parameter needs to be set individually.
When the setting has been carried out, the
In-Wash
emits a beep and the lights in the remote control
blink.
Therefore, if you wish to change the 3 settings of the anal cleaning, by instance, they should be pressed
successively with the activated function
Should you need to connect the remote control again these stored values would be lost.
To return to the pre-set standard values, see section 3.5.
3.4.2 OPERATING MODES LED LIGHTS
There are four operating modes for light in the
In-Wash
:
Mode 1 Standard:
This is the pre-set mode of the product.
The lights remain switched off while the
In-Wash
is not in use.
When the cover is lifted, the lights are switched on. They remain switched on while the product is in use and they switch off one minute after they stop
detecting the user.
Mode 2 Standard with night light:
When this mode is activated, the lights of the
In-Wash
switch on daily for 8 hours and during the remaining 16 hours the In-Wash remains in Standard
mode.
Mode 3 Night light:
When this mode is activated, the lights of the
In-Wash
switch on daily for 8 hours and they remain switched off for the remaining 16 hours.
Mode 4 Switched off:
Lights always switched off.
The Light mode may be modified by means of the auxiliary side control:
• Press the Dryer button on the auxiliary side control for 3 seconds. A beep will be heard and the lights will blink indicating the mode of the
In-Wash
; 1 blink + 1 beep mode 1, 2 2 beeps mode 2 and so on.
• Press successively the
Dryer
button to change the mode 1, 2, 3, 4, 1, 2, 3, 4... until you reach the desired mode. The lights blink 1, 2, 3 or 4
times indicating the selected mode.
• With the selected mode, press the
Stop
button on the auxiliary side control or the remote control, to memorise the option, or wait one minu-
te and the last selected mode will be registered.
3.4.3 SILENCE MODE
The
In-Wash
offers the option of silencing the sound it emits when activating the functions
and settings.
To silence it, with the auxiliary side control, press the
Drying
and
Stop
buttons simultaneously
for 3 seconds.
❚
3.5 RETURN TO DEFAULT SETTINGS
To return to the default settings press the
Drying
and
Stop
buttons on the remote control simultaneously
for 5 seconds.
All previously modified values will be deleted and the
In-Wash
will have its default settings:
• Medium water and drying temperature.
• Medium pressure.
• Middle position.
• Light mode 1 (standard).
• It will also carry out a product self-calibration test, in which water flows out of the nozzle for 2 minutes.
• Silence mode disconnected.
x2
3 s.
3 s.
5 s.
x2
ENGLISH
