Roca GEORGIA, Руководство по установке

Страница: 10 / 12

10 11
Mark the position of the hole in the panel with regard
to the left and right end plugs.
Important!
It is only necessary to drill holes in the ends of the
panel, not in the centre (see figures 7 and 8).
Drill the panel in the place you have marked and
at approximately 60 mm above the floor (see
photo XII).
If two panels are to be fitted, ensure that the holes
(R) are at least 40 mm from the edge of the panel
so that the seal (X) can be fitted easily (figure 8).
Carefully clean the inside surface of the panel with
alcohol before gluing the Velcro in place (V).
Position the panel and remove the adhesive pro-
tectors from the Velcro (V).
Position the panel again putting the upper end below the edge of
the tub and ensuring that the springs (photo V) are inside the edge
of the panel so that they can work correctly.
Bend the panel for it to fit into place under the edge of the bathtub.
The flexible nature of the panel means this can be done without
damage or permanent deformation to the panel (see figures 6.2
and 6.3).
Start fitting it in position at the left end and place it below the edge
of the tub. When you get to each Velcro fastening (V), check that
it is free.
Once the panel is in place, fasten the Velcro (V), by pressing on the
area where they are located. Fit the washers, screws and covers
shown in figure 5b in the holes at the ends. Said screws,
must be
fitted if the tub is installed with a hydromassage.
If the second panel is not to be fitted, finish tiling the walls.
5. ASSEMBLING THE SECOND PANEL
To assemble the supports, proceed as indicated for the first panel
(points 3.1 and 3.2).
Before fitting the second panel, position the supplied chrome trim
section joints (X), as indicated in figure 7, in the ends of the first
panel. Place the section on the first panel beginning at the top
(see photos XIII, XIV).
Xll
Xlll
XlV
Xlll
XlV
Approx. 60 mm