Roca EURET A35945E000, Руководство по установке, Страница: 8 / 20

8
9 Maintenance mode
Maintenance mode
In case that you would like to repair the product, it is not necessary to remove the sensor. Just apply a piece of tape on the sensor
window, the flush after use will be stopped and you may repair it.
Manual flush
1. You may switch to manual flush mode while there is request for cleaning or other purpose.
2. Attach the magnet during 1sec at the below part of sensor for entering into manual mode. Under manual mode, sensor will
deactivates for 5 min,after that, it will perform with 1min flush. ( Apply with a magnet during flushing if you would like to stop
flushing and return to automatic sensor mode).
If during manual mode you would like to advance 1 min forced flush, please attach magnet again at below part of sensor.
Product will flush for 1 min and return to automatic sensor mode.
Switch off flush
In case that you would like to repair the product, you may apply with below methods for switching off the flush:
1. Enter into manual flush mode.
2. Disassemble panel and disconnect the sensor with power.
Low battery indication / battery replacement (A35945E..0 , A35945S..0)
While the sensor indicator flickers every 2 seconds which stands for the batteries are low. While the indicator is on
continuously which means the batteries have already run out. This product is stops sensing and flushing. It requires user to replace
the batteries.
For the instructions of replacing batteries, please refer to “Chapter 4 “ of manual .
Sensor magnet
8 Operational working procedure
Flush activates after user is not
within sensitive range.
While the induction time is more than 2sec, pre-flush will be implemented and if the detection is longer than 7sec, flush will activate
after leaving sensor induction range.
detection time ≥ 7 sec
Environment protection flushing mode
(fixed-time flushing / automatic flush)
In case that this product has not been used for a long period of time, full flush will automatically activate every 24 hours.