Robur AD, Инструкция по установке, использованию и техническому обслуживанию

Страница: 14 / 24

Transport and positioning
14
2
to the flange of the previously prepared duct (Figure
2.3 p. 14).
Figure 2.3 Prepare a flanged duct.
2. Bring the base of the evaporative cooler to the mount-
ing point (Figure 2.4 p. 14).
Figure 2.4
Bring the base of the evaporative cooler to the mount-
ing point.
3. Secure the two flanges (base duct flange-inlet duct
flange) by bolting.
4. It is recommended to place some silicon paste be-
tween the two flanges connections to ensure perfect
insulation from external agents.
5. Position and secure the uprights at the base of the
cooler using the screws provided (Figure 2.5
p. 14).
Figure 2.5
Position and secure the uprights at the base of the
cooler
6. Check the tightening of the hose clamp on the hose
connected to the pump (Figure 2.6
p. 14).
Figure 2.6 Check the tightening of the hose clamp on the hose
connected to the pump
7. Apply the humidifying panels leaning them against
the uprights, keeping the groove, obtained on one
side of the panel, upwards and towards the outside of
the appliance (Figure 2.7 p. 14).
Figure 2.7
Apply the humidifying panels leaning them against
the uprights
8. Insert the water distribution stripes into the pad
grooves. Check that these are pressed down firmly to
the bottom of their seat (Figure 2.8
p. 14).
Figure 2.8
Insert the water distribution stripes into the pad
grooves
9. Insert the water distributor into the grooves of the
humidifying panels making sure that its supports rest
evenly on the pad grooves (Figure 2.9
p. 15).