Robur AD, Инструкция по установке, использованию и техническому обслуживанию

Страница: 15 / 24

Transport and positioning
Installation, use and maintenance manual – AD
15
2
Figure 2.9 Insert the water distributor
10. Keep the hose holder on the side of the appliance
where the water pump is, taking care to make an
opening in the humidifying panel at the hose holder
to allow it to pass through.
11. Connect the flexible hose coming from the pump to
the distributor fitting and secure it with a hose clamp
(Figure 2.10 p. 15).
Figure 2.10
Connect the flexible hose coming from the pump to
the distributor fitting
12. Insert the side and rear grates of the appliance, fix-
ing them with the clips provided. Do not mount the
grate on the front side (component/ connection side)
(Figure 2.11
p. 15).
Figure 2.11
Insert the side and rear grates of the appliance
13. Insert the clips on both sides of the grate, initially up to
the "first click" and then force them until they are com-
pletely inserted so that they do not protrude, in height,
beyond the humidifying panels (Figure 2.12
p. 15
and Figure 2.13
p. 15).
Figure 2.12 Secure by using the clips provided
Figure 2.13
Insert the clips on both sides of the grate
14. Position the cap without securing it so that the front
grate can be fitted later. Raise the cap until the grate is
properly seated (Figure 2.14
p. 15).
Figure 2.14
Position the cap
15. Do not secure the front grate with clips as this would
prevent easy access to the inside of the appliance for
any maintenance operations.
16. Once the protection grates have been positioned, se-
cure the cap with the screws provided.
2.4.2
Wall/window mounting
How to mount the unit on the wall/window
1. Prepare and secure a machine support frame and a
flanged air inlet duct having the same dimensions as
the flanged duct trunk of the appliance, which must
be secured to the flange of the previously prepared
duct (Figure 2.15
p. 16).