Robot Coupe R4X, Руководство по эксплуатации

Страница: 9 / 16

R4X and R6X Operation Manual
9
A diced product requires two actions. First, a hori-
zontal slice is made and then this slice is forced by
the machine through the dicing grid to obtain a verti-
cal cut. This results in a cubed product. The dimen-
sions of this cube are varied via the selection of the
slicing plate and dicing grid.
The 5mm dicing combination is generally used for
potatoes and squash because of its small size.
The 8mm smaller dicing combinations can be used
for finely diced carrots, celery, etc. and readily used
in soups or stews. The larger (14 mm or greater)
dicing combinations work well with fruits such as
apples, pears, pineapple, etc.
When dicing tomatoes, green peppers, onions, or
celery always insure that the product is introduced
into the machine so that the slicing plate will be slic-
ing across the grain of the vegetable.
CAUTION: The softer the produce, the
less acceptable will be the finished prod-
uct.
When dicing tomatoes, green peppers, onions, or
celery always insure that the product is introduced
into the machine so that the slicing plate will be slic-
ing across the grain of the vegetable.
After a time of use, the dicing grid will require clean-
ing. A visible difference in the finished product will
occur when cleaning is required. The best way to
clean the grid is: remove the slicing plate, take a stiff
bristle brush and force the product that is on the grid
to go through.
There are three (3) wave slicing plates available:
Part Number MM Slicing Inches (Approx.)
C445W 2mm Waved 5/64”
C446W 3mm Waved 1/8”
C464W 5mm Waved 3/16”
The waved slicing plates work just like the straight slicing
plates, except that the product has waved or ruffled sides.
This can be an attractive alternative to the flat slices that
are so prevalent on salad bars. By adding a waved plate,
you can dramatically alter the presentation of the food. As
with the straight slicing plates, remember that harder foods
slice best when cut thinner and softer foods slice best when
cut thicker.
While the standard Robot Coupe comes with two specific
plates (C446SA and C450GPA) at time of printing, many
user applications may require some of the optional plates
available with the unit. Typically 5 - 7 plates will perform
most of the functions called by any one customer.
dicing
grid 5x5 mm 8x8 mm 10x10 mm 14x14 mm 20x20 mm 25x25 mm
Plate
5 mm 28110
8 mm 28111
10 mm 28112
14 mm 28113
20 mm 28114
25 mm 28115
The shaded areas indicate additional combinations that can be used.