Robot Coupe R302, Руководство по эксплуатации

Страница: 14 / 18

R302 Operation Manual
14
have been rubbing together (small pieces of
plastic would be present).
2. If this was the case the processing plate was
not fully seated. Check for food particles
inside stem of processing plate.
3. Replace the plate insuring that it is fully
seated. Make sure there are not food par
ticles on the motor shaft.
4. If noise continues, turn unit OFF and remove
processing plate. Assemble unit without plate
and turn unit ON. If no noise—processing
plate may be bent or warped. Try another
plate. If noise persists, call your local factory
authorized service agency.
G. Cucumbers coming out with torn skins and/or with
seeds knocked out
1. Blade is dull on plate and must be changed.
NOTE: Cucumber condition before process
ing should be considered.
H. Carrots are watery after grating
1. Grating grid surface is dull and should be re
placed.
I. Cheese forms balls instead of shreds
1. Warm cheese
2. The grating grid is dull and should be replaced
J. Machine becomes jammed while processing
1. Turn unit OFF, and unplug machine. Remove
continuous feed lead and remove remnants
of product being processed.
Put on a pair
of cut-resistant gloves and try and turn plate
manually in a counterclockwise direction.
CAUTION: This may be very hard to do. As
soon as you feel the plate slip, you will be
able to reassemble the unit and continue pro
cessing. If unit jams again, repeat above until
you get the plate to slip. Now, remove and
clean the plate. Before reassembling, make
sure:
a. Motor shaft is clean.
b. Plate is fully seated on motor
shaft.
2. If jamming is too tight to loosen by hand, contact
service agency.
CAUTION: It is advisable to keep the machine un-
plugged while cleaning or servicing.
TROUBLE SHOOTING AIDS: The following sections
indicate potential problems and the correct solution
which should be implemented by the user. Problems
which extend beyond these will require an experi-
enced serviceman. A list of the authorized agencies
is supplied.
V. TROUBLE SHOOTING AIDS
A. Unit does not start when assembled correctly
1. Pull plug and try another outlet
2. Make sure bowl lid or continuous feed lead is
in the proper position with the pusher located
over the pusher opening.
B. Bowl or continuous feed lead will not fit flush with
continuous feed attachment
1. Processing plate is not in it’s proper position.
2. Rim of plate should be level with upper edge
of motor base.
C. Unit stops during processing
1. Turn unit off, and unplug machine
2. Remove continuous feed lead
3. Remove cutting plate
4. Remove product being processed from inside
of machine and continuous feed lead
5. Reassemble unit
D. If unit does not operate after following above
1. Check outlet for current (Breaker or Fuse)
2. Try unit again
3. Call local authorized service agency.
E. Unit starts to spark or smoke
1. Turn unit off, unplug it, call local authorized
service agency.
F. Unit makes grinding noise
1. Turn unit off, disassemble, check continuous
feed lead and processing plate to see if they