Robot Coupe Mini MP 170 V.V., Руководство по эксплуатации

Страница: 11 / 22

10
W A R N I N G
• WHISK
The success of your preparation will depend essen-
tially on the state of the metal wires and their amount
of wear and tear. They should therefore be replaced
from time to time in order to ensure optimum quality
of the finished product.
• SHAFT SEAL
In order to maintain a watertight seal between the
shaft and bell, inspect the seal for wear and replace
it if necessary.
TROUBLE SHOOTING
THE POWER MIXER DOES NOT START.
- Did you follow the previous operating instructions
?
See section-Operating The Power Mixer.
- Pull the plug and try another outlet.
- Check outlet for current (breaker or fuse).
- Call local Robot Coupe authorized service agency.
THE POWER MIXER STOPS DURING (WHILE)
PROCESSING.
See the section on Operating the power Mixer. The
first paragraph describes the overload protection. It
may be necessary to allow the machine to cool for
up to 30 minutes before restarting.
If you cannot locate the cause of the problem
- Release the control button (CB).
- Unplug the power mixer.
THE BLADES ARE SHARP! It is recommended that
cutting gloves be worn when handling the blades.
Handle and store the blades with safety in mind.
Never try to override or defeat the purpose of the
safety mechanisms!
Never put anything (utensils etc.) but food material
near the blades on the power mixer!
Never overload the power mixer!
Never turn the power mixer on, unless the bell is
completely immersed in the product.
Always unplug the power mixer before doing any
cleaning or maintenance!
- Are the blades free to rotate in the bell
?
- Is the drive shaft free to rotate
?
To check this,
unplug the power mixer, remove the bell and test
the rotation of the end of the drive shaft manually.
Check the condition of the plug and the power cord.
THE POWER MIXER STARTS TO SMELL HOT OR
SMOKE.
Turn the power mixer off and unplug it. Call your
local authorized service agency.
SERVICE
See warranty first then;
Should your unit require service, check with
your distributor to see where local service is
available. If not or if you wish your unit to be
serviced at the factory, call for return instructions and
ship the unit prepaid to our factory address.
PH : 1-800-824-1646
Robot-Coupe USA, Inc
Service Department Repair
264 South Perkins Street
Ridgeland, MS 39157
For service in Canada contact the Robot-Coupe
USA factory for repair instructions.
Mini MP USA 18/12/06 12:56 Page 10