12
Slide the mop cloth in from the
opening of the attachment slot then
stick it flat in place.
C8-2—
If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Note:
Battery
The robot is equipped with a built-in
high-performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
Remove the water tanks and the dustbin
before moving the dock. Grip the handle on
the back with one hand and the inner side
of the front, as shown. Do not grip the base
because as it is not designed for lifting.
C11
Moving the Dock
Use a soft, dry cloth to wipe and clean all
sensors, including:
Use a soft dry cloth to wipe the charging
contacts on the robot and the dock.
C9
Robot Sensors
C10
Charging Contact Areas
* Clean monthly.
* Clean monthly.
Dock Locator
Wall Sensor
Mop Wash Sensor
Carpet Sensor
Cliff Sensors
C9-1—
C9-2—
C9-3—
C9-4—
C9-5—
* Clean as required.
Unlock the water filter and remove it for
washing. Use a soft, dry cloth to wipe the
cleaning tank, and then reinstall the filter.
Press down the filter until you hear it lock
with a click.
C14
Water Filter
Pulling the dust bag handle to remove the bag will seal
the bag to prevent leakage.
Lift the dustbin and remove the
bag vertically as shown.
Discard the dust bag and clean
around the filter with a dry cloth.
Slot in a new disposable dust bag
as shown. Slide until it reaches the
bottom of the slot and reinstall the
dustbin securely.
Always install a dust bag before putting back the
dustbin top lid to avoid auto-emptying without the bag. You
can also disable auto-emptying in the app.
Note:
Note:
*
Replace the disposable dust bag when it is full.
C15-1—
C15-2—
C15-3—
C15
Replacing the Disposable
Dust Bag
* Clean as required.
Remove the clean water tank, dirty
water tank, and dustbin.
Follow the following steps to clean the air
duct and avoid blockages.
C16-1—
C16
Cleaning the Air Duct
* Clean as required.
Lift the high-speed maintenance brush latch
and remove the brush, as shown below.
Remove any entangled objects in the
high-speed maintenance brush and rinse it
clean. Reinstall the brush and latch it in place.
* Clean as required and replace every 6-12 months.
Clean the dirty water tank as needed. Open
the dirty water tank lid and pour out the
dirty water. Fill the tank with clean water,
close the lid, lock it, and shake. Pour out the
dirty water. Close the lid and then re-install.
C12
Dirty Water Tank
C13
High-Speed Maintenance
Brush
C8-1—
* Clean after each use and replace every 3-6 months.
A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
Note:
C8
VibraRise Mop Cloth
Remove the VibraRise mop cloth from
the VibraRise mop mount. Clean the
VibraRise mop cloth and air-dry it.
