Roborock Q400RR, Руководство пользователя

Страница: 11 / 15

11
C8-4— Install a new dust bag in place along the
slot and put the dustbin cover back.
C9
Air Duct
* Replace as needed.
C9-1— Unscrew the screws (10) and remove
the cover.
C9-2— Wipe the air duct and cover with a
dry cloth.
C9-3— Re-install the cover and screw it back
in place.
C10-3— Four Cliff Sensors
C10-2— Wall Sensor
C10
Robot Sensors
* Clean every month
C10-1— Dock Locator
Use a soft, dry cloth to wipe all sensors,
including:
Basic Parameters
Robot
Note: The serial number is on a sticker on the underside of
the robot.
< 6 hours Charging Time
Q400RR Model
14.4V/5200mAh
lithium-ion battery
Battery
Approx. 3.2kg (7.05 lbs. ) Weight
20V 1.2A
20V 1.2A
Rated Input
Clean the charging contacts of the dock and
the robot with a soft, dry cloth.
C11
Charging Contact Areas
The robot is equipped with a high-
performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged during
normal use.
Battery
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
* Clean every month
Notes:
•
Before removing the battery, make sure it is fully drained.
Do not attempt to remove the battery if the robot is
connected to the dock.
•
Remove the entire battery pack. Avoid damaging the
battery pack casing to avoid short-circuits or leakage of
hazardous substances.
•
In the event of accidental contact with battery fluid, rinse
thoroughly with water and seek immediate medical care.
Removing the Battery
Environment
Protection Information
* The following information applies only when disposing
of the robot and should not be followed for day-to-day
operations.
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution. Remove
the battery before disposing of this product
and hand it to a professional battery
recycling facility for centralized disposal.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn off the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the latch to pull out the battery
connector and remove the battery.
50-60Hz
9.5A
0.5A
Rated Input (Dust Collection)
Rated Input (Charge)
Rated Output
Auto-Empty Dock
AED03LRR, AED04LRR
Model
120V~
Rated Input Voltage
Rated Frequency
Charging Battery
14.4V/5200mAh
lithium-ion battery