Robomow MC1200, Оригинальная инструкция по эксплуатации, Страница: 45 / 58

44
Display Message Probable Cause/Event Corrective Actions
E8
Decrease
Inactive Time
- Too many Inactive Days and/or
Hours have been set for your lawn
area. Current settings will not be
changed.
- Mowing Frequency is too high for
current settings of Inactive Time.
The Inactive Time settings will be
set to defaults.
- Area setting is too high for current
settings of Inactive Time. The
Inactive Time settings will be set to
defaults.
- Decrease the number of Inactive Days and/
or the number of Inactive Hours to allow
Robomow to complete mowing your lawn.
- Decrease Mowing Frequency (see p001 in
the table in Section 6.4.2)
- Decrease Area setting
E9
See
Troubleshooting
in Manual
- E 9 is displayed for all other
messages that are not listed in the
above table.
- Press the ‘Right arrow’ button to receive the
stop reason number and refer to the next
table for more details about the stop reason,
causes, and actions.
9.2 Detailed Error Codes
If the above table (Section 9.1) does not give enough information to help solve the problem, then press the LEFT
arrow while the Error Code is displayed in order to receive a detailed error code for the problem and refer to the
table below:
Display Message Probable Cause/Event Corrective Actions
0010
Mow Overheat
- The mowing motor has been
working under a severe load for too
long.
- No need for action – Robomow will renew
automatically the operation after the mowing
motor will cool down.
0011
Drive Overheat
- The drive motors have been working
under a severe load for too long.
-No need to do anything.
-Robomow will renew the operation
automatically as soon as the drive motor will
cool down.
0012
No wire signal -See E3 in the above table
0014
Front wheel
problem
-See E7 in the above table
0015
Button pressed
- One of the operating panel buttons
is constantly pressed.
- Press ‘OK’ to confirm the message and
continue operation. This message is displayed
to inform only.
0016
Low
temperature
- Mower does not depart
automatically from the Base Station
when the ambient temperature is
lower than 5ºC (41ºF).
- Information - When the temperature
is below 5ºC (41ºF) the grass does
not grow or grows very slowly.
However Manual Depart is enabled.
-No need to do anything.
-Robomow will renew the operation
automatically as soon as the ambiance
temperature will rise above 5ºC (41ºF).
0020
Rain detected
- The operation is delayed as
Robomow detects rain.
- Robomow should resume operation
30 minutes after it stops to detect
the rain.
-No need for action.
-
The message is displayed until Robomow will
not detect rain and then will start mowing.
0021
Check mowing
height
- Mowing motor has faced over-
current conditionsfor too long as a
result of high grass or an obstacle
that is stuck or wrapped around the
blade.
- Something is preventing the blade
from rotating freely.
- Severe grass accumulation under
the mowing deck, rope, or similar
object is wrapped around mowing
blade.
- CAUTION – Switch Off the Safety Switch
before checking the blade.
- Inspect the blade for foreign material or debris
preventing rotation.
- Clean out accumulated grass clippings using
a wooden stick.