20
10-V1011
Z3200
Z3200
10-V1011
21
–
English
–
Deutsch
–
English
–
Deutsch
Overhead sawguard
(Fig.26-27)
According norms and applicable prescriptions, the sawguard always should be positioned, just
allowing the passing of the wood or work pieces.
The adjustment of height can be done with the handle (1 and 2), using the previously adapted
graduated scale (3). The guard can not go under the definite measurement. Allowing to block the
protection to avoid it goes up on its own. The handle (2) as well serves as a height stop to avoid that
the protection goes up to high according to the handled work piece.
The guard has got a shifting skirt, remove the screw (1) then the little skirt and place the larger one,
closing again with the screw.
Attention: it is evident that for special tasks, it is necessary to make or build specific protection.
RPM indicator lights
(Fig.28)
After the machine has been switched on by the main
switch, the indicator lights at the front electrical panel
show the speed of the saw arbor. When changing
speed always take care that the indicator detector
(1) is placed in the correct position, to avoid the belt
rubbing against the detector, leading to a premature
wear of the belt.
This can be felt and seen.
The machine has 3 RPMs : 3000 - 4000 - 5000.
Belt tension and speed changing
(Fig.29-30)
maiN saWbelt :
Always choose the speed accordingly the sawblade diameter and never exceed the maximum
allowed cutting speed for carbide tipped sawblades of 100 m/sec.
This is a very important safety rule.
To loosen the belt, pull and turn handle (1) to the left. When the belt has been changed or put in
another groove of the pulleys and the indicator detector (2) has been checked for its correct position,
the belt has to be tensioned. Pull and turn the handle (1) to the right and engage it into the serrated
span sector. (3)
Make sure the belt is not overtensioned, because this leads to damage of the saw arbor and belt.
Check regularly the condition of the belt and, if necessary, replace it (partnr. N8207 : XPA 800
Quadpower).
scoriNg saWbelt :
To tension the scoring sawbelt loosen the two nuts (1-2) which hold the motor, push the
motor down, tighten the two nuts while holding the motor down.
To change the belt remove the motor completely. When the belt is replaced, but before
tensioning it, ensure that it is correctly seated into the grooves of both pulleys.
Fig.29
Fig.30
Fig.28
5000 RPM
4000 RPM
3000 RPM
3
1
2
1
2
Fig.26
Fig.27
