Robland PS 3200, Руководство пользователя

Страница: 21 / 53

–
English
20
Silverline - PS 3200
V0713
Adjusting the cross-cut fence
(Fig.19-20)
All measuring tapes are factory calibrated and the measure is read directly at the index (fig. 19.1).
The optional digital read out, or the normal standard stop, is calibrated as follows: put the 300 mm
calibration gauge
(Z1253) against the cross-cut fence and the saw blade tooth.
Now slide the digital stop up against the gauge and push << F en SET >>.
The read out is now automatically set at 300mm.
In order to check if the normal measuring tape matches the 300 mm at the index (fig.19, 1),
Make a test cut by putting both flip stops at any given position and check if the obtained measures are
correct.
When using the telescopic part of the cross-cut fence (up to 3360 mm) unlock the handle (fig.20.1)
And slide out the extension. Reading is done on the fixed part of the cross-cut fence, or on the optional
digital read out.
By means of the button << inc >> measure is, when pushing the button << Abs >> the absolute
measure is shown. The flip stop is equipped with a fine adjustment, unlock the handle (fig. 19.2) and
lock the serrated knob (fig. 19.3). Now fine adjustment is done by turning the serrated knob (fig.19.4).
After fine adjustment is done, lock the flip stop in place by locking the handle (fig.19.2)
Fig.19 Fig.20