9
Introduction
Thanks for purchasing our Electronic Speed Controller (ESC). The power system for RC model can be very
dangerous, so please read this manual carefully. In that we have no control over the correct use, installation,
application, or maintenance of our products, no liability shall be assumed nor accepted for any damages, losses or
costs resulting from the use of the product. Any claims arising from the operating, failure of malfunctioning etc. will
be denied. We assume no liability for personal injury, consequential damages resulting from our product or our
workmanship.
Features
•
Completely water-proof and dust-proof. The ESC works properly even under water.
(Please remove the cooling fan when running car in water, and after running, please make the ESC clean
and then dry it to avoid the oxidation of copper connectors)
•
Drive sensorless brushless motors.
•
Excellent start-up, acceleration and linearity features.
•
The built-in switching mode BEC has powerful output to supply all electronic equipments.
•
There is a mounting stand for installing the ESC on chassis easily and firmly.
•
Proportional ABS brake function with 4 steps of maximum brake force adjustment, 8 steps
of drag-brake force
adjustment. Also compatible with the mechanical disc-brake system.
•
Multiple protection features: Low voltage cut-off protection / Over-heat protection / Throttle signal loss protection
/ Motor blocked protection
•
Easily programmed with the SET button of the ESC, and also compatible with pocket-sized Program Card.
Warning notes
•
To avoid short circuits, make sure that all wires and connections are well insulated before connecting the regulator.
•
Make sure all components are properly connected to prevent damage to the electrical components.
•
Read the operating instructions of all live components carefully and make sure that the configuration of the
components is attuned to each other.
•
Use a soldering iron with a capacity of at least 60 watts to solder all input / output lines and connections.
•
Do not hold the vehicle in the air and give full throttle. The rubber tires increase in size due to the lack of resistance
and can potentially burst, which can cause serious injury.
•
Stop use and operation as soon as the controller housing exceeds 90 ° C, as this may damage both the controller
and the motor. The factory overheat protection is set to 105
℃
(this corresponds to the internal temperature of the
controller).
•
Always disconnect the battery from the regulator after use. The permanent connection of a battery to the controller
over a longer period of time can lead to damage and / or deep discharge of the battery or regulator. This is NOT
covered by the warranty.
