Robitronic LAP COUNTER USB, Руководство пользователя

Страница: 11 / 16

connectors. If you need only 4 receiver modules you can cut the cable or
simply leave the other connectors free. But don’t forget you need one free
connector to connect the receiver modules with the interface.
Caution: If you operate the system outdoors make sure that no direct
sunlight can shine on the receiver modules. If the receiver modules are in
direct sunlight the system may not operate correctly because the signal
quality is reduced dramatically.
Interface:
If the bridge is ready, you can connect the
interface with the flat cable to the receiver
modules. To avoid interferences the distance
between the interface and the bridge should be as
short as possible.
On the interface you find a mini-USB connector for
the communication with the PC.
When connected, the green Power-LED should
light up. At initial installation, this process can take
a few seconds, the driver is installed automatically.
When putting on also the Action LED should flash
briefly.
Transponder:
When you mount the transponder inside your model you
have to search for a position where the transponder has
direct visibility with the bridge. Otherwise the infrared
signal is not delivered to the receiver modules.
The transponder can be connected directly to the radio
receiver in the model. If you use a receiver pack (for
example in nitro cars) you should only use 4 or 5 cell
receiver packs.
- 11 -