hurricAnE
Turn the steering wheel right to turn the front tires go right. Turn
the steering wheel left to turn the front tires go left.
Press the throttle trigger to moving forward the vehicle.
Push forward the throttle trigger to brake and reverse the vehicle.
2200kv motor combo
Max Input Volts
25.2
Amp Rating
120
Weight
424g (15oz)
Motor Diameter
39.98mm 41.78mm with fins
Motor Length
75.18mm
Shaft
5mm
Bearings
Oversize ABEC-1 front and rear
Connector
6.5mm
mamba monster esc
Cells
4s-6s LiPo
Continuous
120A
Resistance
0.0003 ohms per phase
Brake
Proportional with adjustable
curve
Reversible
Yes - with lockout
Low Voltage Cutoff
Programmable
Size
2.2“ x 1.9“ x 1.4“
Weight w/wires
121g (4.26 oz)
Connector
6.5mm bullet
feaTures mamBa monsTer sysTem
1. Specially designed for RC car RTR (Ready To Run) application.
2. Excellent start-up, acceleration and linearity features.
3. Compatible with sensorless brushless motor.
4. Running modes: Forward mode (single direction) and Forward/Backward mode (dual directions)
5. Proportional ABS brake function, with 4 steps of maximum brake force adjustment, 5 steps of drag-brake force adjustment.
6. Different options of start modes (also called “Punch“) from “soft“ to “aggressive“.
7. Multible protection features: Low voltage cut-off protection for lithium or nickel battery / Over-heat protection / Throttle signal loss pro-
tection / Motor blocked protection.
8. Splash proof and dustproof.
Trouble shooting
Touble
Possible Reason
Solution
After power on, motor doesn‘t work,
and the cooling fan doesn‘t work
The connections between battery pack and ESC are not
correct
Check the power connections
Replace the connectors
After power on, motor can‘t work, but
emits “beep-beep-, beep-beep-“ alert
tone. (Every group of “beep-beep-“
has a time interval of 1sec.)
Input voltage is abnormal, too high or too low
Check the voltage of the battery pack
After power on, red LED always lights,
the motor doesn‘t work
Throttle signal is abnormal
Plug the control wire into the throttle channel of the receiver
correctly
The motor runs in the opposite direc-
tion when it is accelerated
The wire connections between ESC and the motor are not
correct
Swap any two wire connections between the ESC and the motor
The motor suddenly stops running
The throttle signal is lost
Check the transmitter and the receiver.
Check the signal wire from the throttle channel of your receiver
The ESC has entered the Low Voltage Protection Mode or
Over-heat Protection Mode
Red LED flashing means Low voltage protection. Please replace
battery pack. Green LED flashing means Over-heat protection, please
stop running to cool the ESC.
When accelerating quickly, the motor
stops or trembles
1) The battery performs bad under high currents (too low C-rating)
2) The gear ratio is too low (e.g. pinion gear with too many teeth)
3) “Start Mode” (punch) is set too aggressively on the ESC
1) Use better batteries.
2) Use a smaller pinion on the motor.
3) Set “Start Mode” (punch) to a lower value.
5
