hurricAnE
Thank you for purchasing a Robitronic product.
General BuildinG Tips:
`
Please carefully read the instruction manual, safety precautions and warranty provisions before you start assembling and operating this model.
`
Make sure that the ESC’s wires are firmly plugged into the reciever.
`
Clear a work area and try to work on a light color towel to avoid missing dropped parts.
`
Don‘t over-tighten fasteners. Many assembly problems are caused by over-tightening screws or nuts. Don‘t use too large a grip. Please
go slowly and feel restance build. Just snug it up.
`
When it doesn‘t fit, please double check. If an assembly isn‘t going together correctly, then either there really is a bad fit (e.g. a part is
damaged or defective) or a mistake in assembly. Always re-read the instruction when there are any problems. If you cannot figure out
what‘s wrong, always ask dealer, and distributor. Don‘t use force beyond what the instructions call for.
`
Using the right tools makes assembly much easier. The instructions below finely indicate you what to get to make things easier. We
don‘t want to scare you by saing that all these tools are required, but you will have a easier time if you have them. Borrow them from a
friend to check if necessary.
included Tools
required Tools
Helpful equipmenT
Cross Wrench
(17mm)
AA Alkaline or rechargeable batteries for
transmitter, 8pcs.
8 x AA2000EN oder 1 x R05101
Hobby knife
Body Scissors, R06207
(for body cutting)
Needlenose Pliers
Battery Pack Charger
e.g. R01004 Expert LD15z or R01005 Expert LD 16z
Sniper Tool
Metric Size
1.5mm / 2.0mm / 2.5mm
RS611, RS612, RS613
Sniper Tool
Metric Size 3.0mm
RS618
Sniper Tool
Metric Size 5.5mm
(for 3mm nut)
RS601
2 x 2S (7,4 V) or
2 x 3S (11,1 V) Lipo Pack
2
