Robinson Willey 32-170-23, Инструкция по установке и обслуживанию

Страница: 17 / 27

7.1 INSTALL FUEL EFFECT COMPONENTS
The fuel effect components comprise:
(a) Rear Coal
(b) Two Side Cheeks
(c) Coal Bed
(d) Seven Rectangular Coals
The Coal Bed and the loose coals are illustrated in Fig 2. The fire
is supplied with the rear brick effect panel already fitted as
illustrated in Fig 11.
Unpack the pack containing the coal bed and the loose coals
and check that these are undamaged.
DO NOT INSTALL THE FIRE WITH BROKEN OR MISSING
COALS. USE ONLY THE COALS SUPPLIED WITH THE FIRE.
1. The underside of the coal bed has grooves matching
the raised ports of the burner top. Fit the coal bed by
placing it onto the burner. Take care to avoid dama ge as
you insert it past the pilot burner (Refer to Fig 21.).Ensure
that it is correctly located in the burner tray by sliding it
sideways and front to back.
2. Insert the side cheeks by sliding them down the side of the
matrix until they touch the rear brick effect panel. (Refer to
Fig 22.)
17 17
7.0 COMMISSIONING
3. Lower the rear coal into position at an angle as shown in
Fig 23.
4. Ensure that the rear coal drops back towards the rear brick
effect panel and seats correctly into the base coal. (Refer
to Fig 24.)
Fig 22.
Fig 24.
Fig 21.
Fig 23.