3
Installing the Supertub
Confirm if the door or washing machine waste inlet needs to be moved from right to left before securing the
unit to the wall. If needed, please see page 6 of these installation instructions.
1.
Fit the four adjustable feet supplied to the
bottom of the cabinet and adjust to align with
benchtop or washing machine height. Use the
lock nut to secure the feet into desired position.
Tilt laundry tub slightly to assist with access.
Check the top of the laundry tub with a spirit
level to ensure that it is level and check that the
cabinet does not “rock” confirm that the door
operates correctly.
Locknut Bottom of the unit
2.
Line up the laundry tub to the installation position and confirm that there is enough room, if necessary
remove the skirting board at the require distance (560mm) this will allow the unit to sit flush against the
wall. (Check with your local council for building regulations). Remove the laundry tub away from the wall.
3.
Connect the hot and cold 3 way ball valves from
the installation kit to the mains wingbacks using
suitable washers / hemp / ptfe tape.
If fittings are required standard parts are
available at most plumbing supply outlets.
Confirm that the ¾” washing machine cap is
secure and will not leak.
4.
Fit the non-return valve from the installation kit
into the hot 3 way ball valve, ensure that the
flow arrow is the correct way (if fitted the wrong
way no water will come through the valve).
3 way ball valve
Non return valve
Direction of flow
Wing
backs
O-ring to be
inserted first into
the 3 way ball valve