Robin America EX30, Руководство по обслуживанию

Страница: 58 / 78

- 57 -
The spring power is at its maximum when the reel is being wound. Do not put off your hand
nor loosen the pressure of your
fi nger unintentionally.
WARNING
(4) Wind the spiral spring.
-1: Hold the case tightly and rotate the reel counterclockwise until it stops.
(It stops when it is wound approx. 6 turns.)
-2: Turn back the reel slowly by approx. 3/4 turns and hold the reel at the position where the rope hole of the reel
and the rope guide of the case are aligned.
(5) Setting the rope. (2 people required)
-1: Pass the rope end through the rope guide to the
rope hole on the reel and make a knot as shown in
Figure
13-2-D .
-2: Put the rope-end-knot in the reel paying attention
that it will not touch the case. (Figure 13-2-E )
-3: Hold the rope fi rmly with the hand at the position
about 50cm from the rope guide and keep the
rope slightly pull so that the rope will not be wound
in.
-4: Release the hand of the reel gently and wind the
rope slowly by the winding power of the spring
until the knob reaches the rope guide.
Assembly is completed.
* The disassembly and the reassembly have been
completed, however carry out the following to check
if the necessary components have surely been
assembled.
Rope end
Approx. 20mm
13-2-E
13-2-D