61
%ULJKWQHVVFRQWURO
The brightness of the display can be adjusted for when the radio is in standby and for when
it is in use. If you use the unit in the bedroom, you may prefer a lower standby brightness
level than the standard setting. There are 6 Standby brightness levels and 6 levels for when
the radio is in use. To change the current brightness setting please follow these steps.
1. A
SSO\DORQJSUHVV
on the
Info
button to access the display brightness setting.
2. Choose either the High, Medium High, Medium, Medium Low, Low or Off brightness
level. Press the
Tuning
control to set the level. If the radio is playing, then the chosen
brightness will be applied immediately. If the radio is in standby, then the chosen
brightness will be applied after a 10 second delay.
3. To set the display brightness using the menu press
Menu
.
4. Choose
'System settings'
and then
'Brightness'.
5. To adjust the display brightness when the radio is switched on select
'Normal'
.
To adjust the display brightness when the radio is in standby select
'Standby'
.
Press
Tuning
. The current setting will be marked with an asterisk.
6. Choose either the High, Medium High, Medium, Medium Low, Low or Off brightness
level. Press the control to set the level. Press the
Menu
button to exit.
When the radio is in Standby mode, pressing a button or turning a rotary control will cause
the radio to switch to the high brightness level for a few seconds. This is so that even if
the standby brightness level is set low, it is still possible to see the time when needed.
Normal
Standby
Brightness
Brightness
High
Medium High
Medium
Medium Low
Low
Off
*
Equaliser
Network
Time/Date
Brightness
Language
Factory Reset
System settings
Headphone socket
A 3.5mm
Headphone Socket
located on the rear of your radio is provided for use with
headphones. Inserting a plug automatically mutes the internal loudspeaker. Please be
aware that the sensitivity of headphones can vary widely. We therefore recommend setting
volume to a low level before connecting headphones to the radio.
IMPORTANT:
Excessive
sound pressure from earphones and headphones can cause hearing loss.
To prevent possible hearing damage, do not listen at high volume levels
for long periods.
Stream 94i
USB
DC Input
:DC 12V
:DC 5V
2.2A
500mA
N16269
DISCONNECT FROM MAINS
BEFORE REMOVING ANY COVER
AND WHEN NOT IN USE.
DO NOT EXPOSE TO MOISTURE
USE ONLY THE PROVIDED MAINS
ADAPTOR
PO Box 130, Mexborough, South Yorkshire, S64 8YT
Brightness
High
Medium High
Medium
Medium Low
Low
Off
*