Roberts Gorden Vantage V040NP, Инструкция по эксплуатации

Страница: 21 / 28

SECTION 7: O
PERATION AND
M
AINTENANCE
17 of 21
eq u ipment m u st perform a thoro u gh safety
inspection of the heater.
For best performance, the gas, electrical, thermostat
connections, t
u bing, v enting, s u spensions and
o v erall heater condition are some of the areas
req u iring inspection.
NOTE: Gas flo w and b u rner ignition are among the
first things that sho u ld be inspected.
Please see Page 17, Section 7.5 for s u ggested items
to inspect.
7.5 Maintenance Checklist
Installation Code and Annual Inspections:
All installation and ser v ice of ROBERTS GORDON
®
eq u ipment m u st be performed by a contractor
q u alified in the installation and ser v ice of eq u ipment
sold and s u pplied by Roberts-Gordon LLC and
conform to all req u irements set forth in the
ROBERTS GORDON
®
man u als and all applicable
go v ernmental a u thorities pertaining to the
installation, ser v ice, operation and labeling of the
eq u ipment.
To help facilitate optim u m performance and safety,
Roberts-Gordon LLC recommends that a q u alified
contractor cond u ct, at a minim u m, ann u al
inspections of yo u r ROBERTS GORDON
®
eq u ipment and perform ser v ice w here necessary,
u sing only replacement parts sold and s u pplied by
Roberts-Gordon LLC.
The Vicinity of the Heater Do not store or u se flammable objects, liq u ids or v apors near the heater.
Immediately remo v e these items if they are present.
See Page 11, Section 6 .
Vehicles and Other
Objects Maintain the clearances to comb u stibles.
Do not hang anything from, or place anything on, the heater.
Make s u re nothing is lodged u nderneath the reflector, in bet w een the t u bes or
in the decorati v e or protecti v e grilles (incl u ded w ith select models).
Immediately remo v e objects in v iolation of the clearances to comb u stibles.
See Page 11, Section 6 .
Reflector S u pport reflector w ith reflector hanger and s u pport strap.
Reflector m u st not to u ch t u be.
Make s u re there is no dirt, sagging, cracking or distortion.
Do not operate if there is sagging, cracking or distortion.
Make s u re reflectors are correctly o v erlapped.
Clean o u tside s u rface w ith a damp cloth.
Vent Pipe Venting m u st be intact. Using a flashlight, look for obstr u ctions, cracks on the
pipe, gaps in the sealed areas or corrosion.
The area m u st be free of dirt and d u st. Clean as req u ired.
Remo v e any carbon deposits or scale u sing a w ire br u sh.
Outside Air Inlet Inlet m u st be intact. Look for obstr u ctions, cracks on the pipe, gaps in the
sealed areas or corrosion.
The area m u st be free of dirt and d u st. Clean and reinstall as req u ired.