Roberts Gorden Combat UHA-150, Инструкция по установке, эксплуатации и обслуживанию

Страница: 41 / 62

SECTION 13: S
ERVICING
33 of 51
13.7 Ventin g and Air Intake Pipe
Inspect all venting and air intake pipe. Ens u re that
all seams are sealed and s u spension points sec u re.
Repair s u spension points if any part of the venting
or comb u stion air pipe is sagging. Check to make
s u re any ins u lation is not missing or in poor
condition. Replace as necessary. Check all venting
and air intake components to ens
u re they are in
good condition, gas tight and corrosion-free.
13. 8 Maintenance Checklist
Installation Code and Annual Inspections: All
installations and service of ROBERTS GORDON ®
eq u ipment m u st be performed by a contractor
q u alified in the installation and service eq u ipment
sold and s u pplied by Roberts-Gordon LLC and
conform to all req u irements set forth in the
ROBERTS GORDON ® man u als and all applicable
governmental a u thorities pertaining to the
installation, service, operation and labeling of the
eq
u ipment.
To help facilitate optim u m performance and safety,
Roberts-Gordon LLC recommends that a q u alified
contractor cond u ct, at a minim u m, ann u al
inspections of yo u r ROBERTS GORDON ®
eq u ipment and perform service w here necessary,
u sing only replacement parts sold and s u pplied by
Roberts-Gordon LLC.
Annual Fall Start-Up Follo w entire start- u p proced u re at this time and check control settings and
operation.
The Vicinity of the Heater Do not store or u se flammable objects, liq u ids or vapors near the heater.
Immediately remove these items if they are present.
See Page 6, Section 3 .
Vehicles and Other
Objects Maintain the clearances to comb u stibles.
Do not hang anything from, or place anything on, the heater.
Make s u re nothing is lodged in bet w een the heat exchanger or in the lo u vers.
Immediately remove objects in violation of the clearances to comb u stibles.
See Page 7, Section 4 .
Vent Pipe/Terminals Venting m u st be intact. Using a flashlight, look for obstr u ctions, cracks on the
pipe, gaps in the sealed areas or corrosion.
The area m u st be free of dirt and d u st.
Remove any carbon deposits or scale u sing a w ire br u sh.
If the vent terminal has a screen b u ilt in, remove any dirt, d u st or deposits
from the screen.
See Page 18, Section 8 .
Cabinet Exterior After installation, to u ch u p scratches. Periodic paintings sho u ld be done
thereafter as req u ired. Warning labels and logo labels sho u ld be legible and
acc u rate. Please contact Roberts-Gordon LLC or ROBERTS GORDON ®
independent distrib u tor if yo u need replacement w arning labels or logo labels
See Page 2, Figure 1 through Page 4, Figure 3 .
Combustion Air Intake
Pipe Intake pipe and inlet m u st be intact. Look for obstr u ctions, cracks on the pipe,
gaps in the sealed areas or corrosion.
The area m u st be free of dirt and d u st.
Clean and reinstall as req u ired.
See Page 18, Section 8 .