S
YSTEM
C
ONTROL
I
NSTALLATION
, O
PERATION
AND
S
ERVICE
M
ANUAL
2 of 12
SECTION 1: INTRODUCTION
Your Safety is Important to Us!
This symbol is used throughout
the manual to notify you of
possible fire, electrical or burn
hazards. Please pay special atten-
tion
w
hen reading and follo
w
ing
the
w
arnings in these
sections.
Installation, service and annual inspection of
controller must be done by an electrician qualified in
the installation and service of control systems for
heating equipment.
Installation, service and annual inspection of heater
must be done by a contractor qualified in the
installation and service of gas or oil fired heating
equipment.
Read this manual carefully before installation,
operation, or service of this equipment.
The equipment must be applied and operated under
the general concepts of resonable use and installed
using best building practices.
This equipment is not intended for use by persons
(including children)
w
ith reduced physical, sensory or
mental capabilities, or lack of experience and
kno
w
ledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do
not play
w
ith the equipment.
For optimum heater performance and safe heating
conditions, inspect and maintain heater(s) before
every heating season and as necessary. Also, kno
w
and maintain heater clearances to combustibles, see
heater Installation, Operation and Service Manual for
further details. If you require additional manuals, con-
tact Roberts-Gordon at +44 (0)121 506 7700 or at
www
.robertsgordon.co.uk.
1.1 Electrical Re
q
uirements
Failure to comply
w
ith the installation instructions
w
ill
invalidate the limited
w
arranty.
All
w
iring must comply
w
ith current
w
iring regulations
and any local regulations
w
hich may apply. Al
w
ays
s
w
itch off electrical supply to equipment and discon-
nect by removing plug before
w
orking on equipment.
Equipment must be electrically grounded in accor-
dance
w
ith local specifications and codes.
1.2 Check Installation Materials
Before proceeding
w
ith installation of ROBERTS
GORDON
®
COMBAT
®
HVE Fan, check the follo
w
ing
points:
1.2.1 Control Options
Each HVE Fan has a built in thermostat that allo
w
s it
to turn on
w
hen ambient temperature at fan exceeds
thermostat’s setpoint. In addition, HVE Fans can be
used
w
ith a number of different speed control
options.
Control Options Specifications
DANGER
Electrical Shock Hazard
Disconnect electric before service.
Equipment must be properly
g
rounded.
Failure to follow these instructions can
result in death or electrical shock.
Model
WAC6
DP5
BJ8
Control Unit Capacity (No. of Fans)
HVE400
1
4
8
HVE450
N/A
1
2
HVE650
N/A
1
2
Manual On/Off
Yes
Yes
Yes
Manual Fan Speed Adjustment
Yes
Yes
No
Automatic Fan Speed Adjustment
No
No
Yes
Fans ‘ON’ Neon Indicator
Yes
No
No
Temperature Sensor Range
[°C]
N/A
N/A
0-40
Temperature Sensor Cable Length
[m]
N/A
N/A
10
Maximum Starting Current
[A]
3
10
20
Maximum Running Current
[A]
1.5
5
10
