EN
EN - 30 -
6.3 Electronic thermal management system
In case of overheating, light intensity will be reduced by the system.
Power reduction and temperature values are available by using a RDM protocol compatible device.
6.4 Firmware update
CCT
selection
Until now, the CCT of the LED source was not taken into account. From V3.0, your device will be
automatically recognized as CW or WW source.
Devices shipped with firmware prior to V3.0 do not have a designated CCT.
After updating to V3.0, it is highly recommended to specify the CCT of your device.
For this you will have to stay on the Web Page that you used for the update.
In the
Source
section of the HOME tab, the CCT of your device is indicated.
• If "unknown", please select the CCT of your device and click on icon or , then on the arrow .
• Changing the source type changes the Model_ID as well. It is used in libraries to recognize devices
automatically and for an Auto-Patch.
• If the source type has to be changed or in case of typing error, it will be always possible to change
the source type in the Expert mode which is protected by a password.
After updating your device with firmware V3.0, we strongly recommend that you
update the source type (CCT) either to CW (Cold White) or WW (Warm White) by following
the procedure described in the section below:
CCT selection
