- 7 -
4.2.3 4.2.3 Emergency mode
By unplugging the DMX IN connector, the following message will be displayed :
“Push select to reset DMX values”
→
By pushing select, DMX values will be deactivated until DMX comes back, so local control
values (local control handle, RJNET, P1FCAN) will control the module from 0 to 100%.
4.3 RJNET control board
The RJNET control board allows :
•
set-up DMX address
•
reset each module independently without turning off the unit
•
see feedback information
•
do tests and adjusts local values
4.3.1 Display and controls
Main view activated after 5 seconds of inactivity :
Lamp :
Sun = ON
Moon= OFF
Dimmer level
(bargraph)
Dimmer value
(%)
If « * » flickering :
Value on mode control
Lamp hour counter
Master value
Dimmer control
:
Highest command detected
d : DMX
a : Local control (handle)
p : P1FCAN
l : Local value
M : Master
1
2
3
4
5
6
7
display
exit
-
+
select
reset
Data
Display
Exit the current menu option and/or go back
Scrolls through menus and/or Decrease blinking data value
Scrolls through menus and/or Increase blinking data value
Enter the current menu option and/or valid
Hard CPU reset
DMX LED feedback
1
2
3
4
5
6
7
