Part no. 209-1416 07/21/2021
Craft Series & Curated Bath Vanity
4
© 2021 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
SECURE THE VANITY
1. Mark the locations of the studs on top-most back rail of the vanity.
2. Using a drill bit, drill two pilot holes through the back rail and into the finished wall and stud.
3. Secure the vanity to the wall with two screws* and washers (not provided). Shim as required to keep the vanity level.
4. Reinstall drawers (See page 5).
CAUTION:
Risk of product damage. Drill pilot holes into the back rail to provide support and to prevent shifting of the vanity.
2
1
* Robern recommends using at least two construction screws to secure the vanity to the wall. Use screws that are long enough to pass
through the vanity back rail, the finished wall, and into the stud. Larger vanities may require more than two screws to secure to the wall.
