7
4. Installation
4.1.Sound-control
The sound-control either works via the ¼” mono jack-socket or the built-in microphone.
If the DMX CONTROL 24 PRO CT is supposed to work via a soundsignal at the Audio In-socket, connect the ¼“
jack socket with the soundsignal of your headphones output or a second adjustable output (if existing) of your
mixer, or with the loud-speaker output of your amplifier.
Tip:
Data +
Sleeve:
Ground
Caution:
Never connect the sound input with the DMX-output, as this will destroy the electric (DMX-driver).
4.2.DMX-512 connection with the projectors
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with the
fixture or one fixture with another.
Occupation of the XLR-connection:
DMX - output
DMX-input
XLR mounting-socket:
XLR mounting-plug:
If you are using the standard controllers, you can connect the DMX-output of the controller directly with the DMX-
input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other DMX-outputs, you
need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the DMX CONTROL 24 PRO CT with the DMX-input of the nearest projector. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution:
At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 ohms resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
1
- Ground
2
- Signal (-)
3
- Signal (+)
1
- Ground
2
- Signal (-)
3
- Signal (+)
