Robe Robin SuperSpike, Руководство пользователя

Страница: 9 / 47

9
3.3 Rigging the fixture
A structure intended for installation of the fixture (s) must safely hold weight of the fixture(s) placed on it. The
structure has to be certificated to the purpose.
The fixture (fixtures) must be installed in accordance with national and local electrical and construction codes
and re gulations.
For overhead installation, the fixture must be always secured with a safety wire that
can bear at least 10 times the weight of the fixture.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled
person once a year.
The fixture should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all installation
materials and the fixture. If you lack these qualifications, do not attempt the installation yourself, but instead use
a professional structural rigger. Improper installation can result in bodily injury or damage to property.
The fixture has to be installed out of the reach of people.
The fixture must never be fixed swinging freely in the room.
Caution:
Fixture may cause severe injuries when crashing down! If you have doubts concerning the safety of
a possible installation, do not install the moving head!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the fixture’s weight.
When installing the device, make sure there is no highly inflammable
material (decoration articles, etc.) in a distance of min. 0.4 m.
Min. distance to lighted object: 2 m
CAUTION!
Use an appropriate clamp to rig the fixture on the truss.
Make sure that the device is fixed properly! Ensure that the
structure (truss) to which you are attaching the fixture is secure.
The fixture can be placed directly on the stage floor or rigged on a truss without altering its operation characte-
ristics.
Due to very fast pan/tilt movement of the fixture, the fixture has to be always anchored
to the ground (base) otherwise there is a danger of knocking the fixture over.
For securing the fixture to the truss install a safety wire that can hold at least 10 times the weight of the fixture.
Use only the safety wire with a snap hook with screw lock gate. Fasten the snap hook in the attachment point
and the safety wire around the truss as shown on the picture below.
.
.